SeaSmart® - The intelligent marine toilet sanitizer

Tel: +44 (0)1425 281004

SeaSmart Marine | Canal Boat

Electric Visual Installation Guide

                      Step 1                                                                                                                         

Electric_1Electric_1.2Manual_1.2

Fit your SeaSmart within 40 cms (16”) of your flush pump’s inlet sanitation hose connection.

(or anywhere your inlet sanitation hose is accessible between the flush pump and the seacock - see page 3 

“Installing into Sanitation Hose”) Note: Your Seasmart can be fitted above or below the “T” piece connection. 

 

                      Step 2                                                                                                                Step 3    

Electric_2                     Electric_3  Electric_3.1 Electric_3.2

Close the seacock and disconnect the inlet                                              Slide the very thin sanitiser tube down

sanitation hose from the pump. If your                                                      inside the inlet sanitation hose until it   

sanitation hose is stiff and difficult to                                                         reaches the seacock. Measure the excess  

disconnect, try warming it up with a hair                                                   of the thin sanitiser tube. Remove the tube   

dryer or hot water to help.                                                                         from the hose and cut off the excess from the                                                                                                                       
                                                                                                                  bottom of the thin sanitiser tube plus 15cm (6”).   

                     Step 4                                                                                                                Step 5   

  Electric_4                                                                 Electric_5

Slide the very thin sanitiser tube back down inside                                             Open the SeaSmart and fit the battery 

the inlet sanitation hose and reconnect the sanitation                                         and the sanitiser pouch.

hose onto the SeaSmart “T” piece.

*DO NOT OVER TIGHTEN HOSE CLAMPS!

- use a screwdriver not a socket wrench.

                       Step 6

Electric_6 

Press the Priming Button for at least 40 

seconds then flush your toilet.

You will see blue sanitised water.

Visit the Online Shop To Get The Solution

Read the
FAQs

Click here to view

Learn about the
Technology

Click here to view

Need more info?
Contact Us

Click here to get in touch